The Box we propose is made of perimeter thermal walls and thermal ceiling in sandwich panels. It is designed and built to house both painting booths and drying columns for the extraction of the vapors exhaled during the drying of the artifacts. On the roof, built on purpose with a reinforced corrugated section, there can be installed a pressurizer which will reintegrate the air drawn in from the cabin and create an overpressure inside the box.

EN/S

Dry paint spray booths for high efficiency filtration of dust generated by finishing operations. Supplied off the shelf with electric panel, ceiling light, differential pressure switch, spray go-ahead and already set up for activated carbon filtration. Average speed over whole section ca. 0.5 m/s.

EN/VR-VG

Paint spray booths for filtration of dust generated by finishing operations with dual water wash system, supplied off the shelf with electric panel, ceiling light, differential pressure switch, electrovalve for consent to running of painting spray-gun and already set up for activated carbon filtration.

In order to best meet your aspiration needs for the emissions produced by the painting operations, we intend to propose a painting booth with water film filtration.
This booth, made of galvanized sheet panels, is equipped with an electrical panel with operating hour counter, differential pressure switch for filter clogging alarm, safety solenoid valve for the operation of the painting system only when the booth is in operation, ceiling lights of about 600 lux and predisposition for the insertion of activated carbon cartridges. The electric fan ensures uniform suction over the entire surface, with speed that meets the current EC regulations. The cabin can be supplied with a water collection tank, coveringwith a metal grid.
The collection tank will be positionedin such a way that it will remain aligned with the floor.
The air sucked and filtered from the booth will be expelled into the atmosphere through vent piping with an increased diameter. It also has a a rain cover system with an open top and ports for sampling analysis in accordance with “UNI 10169”.

S3515

Dry paint spray booths for filtration of dust generated by finishing operations, with built-in soundproof suction system, complete with ceiling light, electric panel and differential pressure switch. Average speed over whole section 0.35 m/s.

This cabin is equipped with an electrical panel with an operating counter, ceiling light with 4 neon 36W / each (approximately 600 lux of light intensity) and is completely soundproofed. The structure is made of press-folded galvanized steel and has been designed to be assembled even by unskilled personnel and in a very short time.
The electric-fan ensures uniform suction over the entire useful surface for a total flow rate of 12,000 m3 / h. The engine is located inside the cabin itself, a feature that reduces noise emissions.
The air sucked in and filtered from the cabin will be expelled into the atmosphere through an over-roof vent pipe with an increased diameter, complete with a rain cover system with an open top and analysis sampling ports in accordance with “UNI 10169”.

Dry booths CR-S

The dry painting booth mod. CRS complete with 2.2 kW aspirator, start/stop panel, support surface, lighting fixture and filter media in foam-paper, is most commonly used in spray painting operations.

This cabin is equipped with an electrical panel with an operating counter, ceiling lights with 4 neon 36W/each (approximately 600 lux of light intensity) and is completely soundproofed. The structure is made of press-folded galvanized steel and has been designed to be assembled even by unskilled personnel and in a very short time.
The electric-fan ensures uniform suction over the needed surface for a total flow rate of 12,000 m3/h. The engine is located inside the cabin itself, a feature that reduces noise emissions.
The air sucked and filtered from the booth will be expelled into the atmosphere through vent piping with an increased diameter. It also has a a rain cover system with an open top and ports for sampling analysis in accordance with “UNI 10169”.